Transfer Case Oil Seal
REPLACEMENT1. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE (1MZ-FE ENGINE TYPE)
2. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE (2AZ-FE ENGINE TYPE)
3. REMOVE FRONT DRIVE SHAFT ASSY RH [43410 / 98-68]
4. REMOVE TRANSFER CASE NO. 1 PLUG [36114B / 98-58]
5. REMOVE TRANSFER DRAIN PLUG [36114F / 98-58]
6. REMOVE TRANSFER STIFFENER PLATE RH [36118A / 98-58]
7. REMOVE TRANSFER ASSY [36100 / 98-57]
8. REMOVE TRANSFER CASE OIL SEAL [36111B / 98-58]
a. Using SST, remove the oil seal from the case.
SST 09308-00010
NOTICE: Do not damage the oil-seal-fitted surface of the case.
9. INSTALL TRANSFER CASE OIL SEAL [36111B / 98-58]
a. Using SST, drive a new oil seal into the case to the position shown in the illustration.
SST 09387-00010, 09950-70010 (09951-07150)
NOTICE: Do not install it obliquely.
b. Apply small amount of MP grease to the oil seal lip.
10. INSTALL TRANSFER ASSY [36100 / 98-57]
11. INSTALL FRONT DRIVE SHAFT ASSY RH [43410 / 98-68]
12. INSTALL RACK & PINION POWER STEERING GEAR ASSY [44250 / 98-76]
13. INSTALL ENGINE ASSEMBLY WITH TRANSAXLE (1MZ-FE ENGINE TYPE)
14. INSTALL ENGINE ASSEMBLY WITH TRANSAXLE (2AZ-FE ENGINE TYPE)
15. INSTALL FRONT WHEEL
16. INSTALL TRANSFER DRAIN PLUG [36114F / 98-58]
a. Install the drain plug with a new gasket.
17. INSTALL TRANSFER CASE NO. 1 PLUG [36114B / 98-58]
a. Supply oil up to the level 0 - 5 mm (0 - 0.1968 inch) down from the lowest end of the plug hole.
Oil quantity: 0.9 L (0.95 US qts., 0.71 Imp. qts.)
NOTICE: When supplying oil, be careful to do it slowly.
b. Install the No. 1 plug with a new gasket.
Torque: 49 Nm (500 kgf-cm, 36 ft. lbs.)