Speed Sensor, Rear
REPLACEMENTHINT: Replace the RH side by the same procedure with LH side.
1. REMOVE REAR WHEEL
2. REMOVE REAR DOOR SCUFF PLATE OUTSIDE LH [67916/98-115]
3. REMOVE REAR FLOOR FINISH PLATE [58387B/98-117]
4. REMOVE DECK TRIM SIDE PANEL ASSY LH [64740C/98-117]
5. REMOVE SPEED SENSOR REAR LH [89546/98-170]
a. Disconnect the speed sensor connector, and pull out the sensor wire harness with grommet.
b. Remove the 2 clamp bolts holding the sensor harness from the body and shock absorber.
c. Remove the bolt and speed sensor rear LH.
NOTICE: Do not stick and foreign matter on the sensor tip.
6. INSTALL SPEED SENSOR REAR LH [89546/ 98-170]
a. Install the speed sensor rear LH with the bolt.
Torque: 20 Nm (205 kgf-cm, 15 ft. lbs.)
NOTICE: Do not stick and foreign matter on the sensor tip.
b. Install the sensor harness clamps with the 2 bolts to the body and shock absorber.
Torque: 5.0 Nm (51 kgf-cm, 44 inch lbs.)
c. Push in the sensor wire harness with grommet and connect the speed sensor connector.
7. INSTALL DECK TRIM SIDE PANEL ASSY LH [64740C/98-117]
8. INSTALL REAR FLOOR FINISH PLATE [58387B/98-117]
9. INSTALL REAR DOOR SCUFF PLATE OUTSIDE LH [67916/98-115]
10. INSTALL REAR WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft. lbs.)
11. CHECK ABS SPEED SENSOR SIGNAL.