Speed Sensor, Front
REPLACEMENTHINT: Replace the RH side by the same procedures with LH side.
1. REMOVE FRONT WHEEL
2. REMOVE FRONT FENDER LINER LH [53876A/98-97]
3. REMOVE SPEED SENSOR FRONT LH [89543/98-170]
a. Disconnect the speed sensor connector.
b. Remove the 2 clamp bolts holding the sensor harness and clamp from the body and shock absorber.
c. Remove the bolt and speed sensor FR LH.
NOTICE: Do not stick and foreign matter on the sensor tip.
4. INSTALL SPEED SENSOR FRONT LH [89543/98-170]
a. Install the speed sensor FR LH with the bolt.
Torque: 8.0 Nm (82 kgf-cm, 71 inch lbs.)
NOTICE: Do not stick and foreign matter on the sensor tip.
b. Install the sensor harness clamps with the 2 bolts "A" and "B" to the body and shock absorber.
Torque:
Bolt A: 5.0 Nm (51 kgf-cm, 44 inch lbs.)
Bolt B: 29 Nm (296 kgf-cm, 21 ft. lbs.)
c. Connect the clamp to the knuckle.
d. Connect the speed sensor connector.
5. INSTALL FRONT FENDER LINER LH [53876A/98-97]
6. INSTALL FRONT WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft. lbs.)
7. CHECK ABS SPEED SENSOR SIGNAL