Quarter Window Glass: Service and Repair
REMOVAL1. REMOVE DOOR SCUFF PLATE
Remove the 4 screws and plate.
2. REMOVE BACK PANEL UPPER GARNISH AND BACK PANEL TRIM
a. Using a screwdriver, remove the back panel upper garnish.
HINT: Tape the screwdriver tip before use.
b. Remove the 3 bolts and back panel trim.
Torque: 9.8 N.m (100 kgf.cm, 7 ft.lbf)
3. REMOVE BACK PANEL LOWER GARNISH
Using a screwdriver, remove the back panel lower garnish.
HINT: Tape the screwdriver tip before use.
4. REMOVE REAR SEAT CUSHIONS
Remove the 4 bolts and rear seat cushions.
Torque: 9.8 N.m (100 kgf.cm, 7 ft.lbf)
5. REMOVE FRONT AND REAR SEAT OUTER BELT ANCHORS
Remove the 4 bolts, seat belt anchors and belt guide.
Torque: 43 N.m (440 kgf.cm, 32 ft.lbf)
6. Remove Lock Handle
a. using a screwdriver,remove the cover.
HINT:Tape the screwdriver tip below use.
b. remove the 2 screws and lock handle.
7. REMOVE QUARTER TRIM
a. Remove the screw and coat hook.
b. Using a screwdriver, remove the quarter trim.
NOTE: Paying enough attention remove the clip on the quarter trim shown in the illustration. Otherwise, the quarter trim or the front pillar garnish might be broken.
HINT: Tape the screwdriver tip before use.
8. REMOVE QUARTER WINDOW GLASS
a. Remove the 4 nuts and quarter window glass.
b. Remove the lock handle from the quarter window glass.
c. Remove the 2 hinges from the quarter window glass.
INSTALLATION
Installation is in the reverse order of removal.