Removal and Installation

Blower Unit





REMOVAL
1. REMOVE THESE PARTS:
a. Glove compartment door
b. Glove compartment door reinforcement
c. Lower No.2 finish panel
d. No.4 heater to register duct
e. Front door scuff plate RH
f. Cowl side trim RH
g. Cooling unit




2. REMOVE BLOWER UNIT
a. Disconnect the connector from the blower motor.

b. Disconnect the air inlet damper control cable from the blower motor.

HINT: At the time of installation, please refer to the following item.

For installing the control cable, refer to "INSTALLATION" of "HEATER CONTROL ASSEMBLY".

c. Remove the nut, bolt and blower unit.

INSTALLATION
Installation is in the reverse order of removal.



Blower Motor

REMOVAL

1. REMOVE GLOVE COMPARTMENT DOOR




2. REMOVE BLOWER MOTOR
a. Disconnect the connector.
b. Remove the 3 screws and motor.

INSTALLATION
Installation is in the reverse order of removal.