Removal and Installation

Part 1 Of 2:

Part 2 Of 2:

REMOVAL
1. DRAIN ENGINE COOLANT
2. REMOVE RADIATOR GRILLE





a) Remove the 4 screws, 2 clips and clearance lights.





b) Remove the 2 filler.
c) Remove the 11 clips and radiator grille.





3. DISCONNECT AIR PIPE
Remove the 2 bolts and disconnect the air pipe.





4. DISCONNECT UPPER RADIATOR HOSE
5. DISCONNECT RADIATOR RESERVOIR HOSE
6. DISCONNECT LOWER RADIATOR HOSE
7. REMOVE NO.2 FAN SHROUD
8. A/T:
DISCONNECT OIL COOLER HOSES





9. REMOVE RADIATOR
Remove the 4 bolts and radiator.
Torque: 12.5 Nm (125 kgf-cm, 9 ft. lbs.)

HINT: At the time of installation, please refer to the following items. Insert the tabs of the radiator support through the radiator service holes.

DISASSEMBLY





1. REMOVE NO.1 FAN SHROUD
Remove the 4 bolts and fan shroud.





2. REMOVE RADIATOR SUPPORTS
Remove the 4 screws and 2 radiator supports.

HINT: At the time of assembly, please refer to the following items. Insert the tabs the radiator upper tank through the radiator support holes.

Torque: 5.5 Nm (55 kgf-cm, 49 inch lbs.)

REASSEMBLY
Reassembly is in the reverse order of disassembly.

INSTALLATION
Installation is in the reverse order of removal.