Removal and Installation

REMOVAL
1. DISCONNECT LEVEL WARNING SWITCH CONNECTOR
2. TAKE OUT FLUID WITH SYRINGE

NOTICE: Do not let brake fluid remain on a painted surface. Wash it off immediately.





3. DISCONNECT BRAKE LINES
Using SST, disconnect the 5 brake lines.
SST 09023-00100
Torque: 15 Nm (155 kgf-cm, 11 ft. lbs.)





4. REMOVE MASTER CYLINDER
a. Remove the 4 nuts, 3-way and check valve bracket.
Torque: 13 Nm (130 kgf-cm, 9 ft. lbs.)
b. Pull out the master cylinder and gasket.

INSTALLATION

HINT:
^ Before installation, adjust the length of the brake booster push rod.
^ After installation, fill the brake reservoir with brake fluid, bleed brake system and check for leaks.
Brake Bleeding

^ Check and adjust the brake pedal.
Testing and Inspection