Drive Belt: Service and Repair
REMOVAL1. REMOVE PS PUMP DRIVE BELT
2. REMOVE ENGINE UNDER COVER
3. LOOSEN IDLE PULLEY LOCK NUT
Torque: 39 Nm (400 kg.cm, 29 ft.lb)
4. REMOVE COMPRESSOR DRIVE BELT
Loosen drive belt tension by adjusting bolt and remove the drive belt.
INSTALLATION
1. TIGHTEN IDLE PULLEY LOCK NUT TEMPORALLY
Torque: 2.5 Nm (25 kg.cm, 22 in.lb)
2. INSTALL DRIVE BELT
3. USING ADJUSTING BOLT, ADJUST DRIVE BELT TENSION
Drive belt tension
New belt: 160 ± 25 lb
Used belt: 100 ± 25 lb
4. TIGHTEN IDLE PULLEY LOCK NUT
Torque: 39 Nm (400 kg.cm, 29 ft.lb)
5. INSTALL PS PUMP DRIVE BELT
6. INSTALL ENGINE UNDER COVER