Removal and Installation

REMOVAL
1. DRAIN ENGINE COOLANT
2. REMOVE FRONT BUMPER FILLER
3. REMOVE RADIATOR GRILLE





a) Remove the 4 screws and clearance lights.





b) Remove the 1 screw, 11 clips and radiator grille.
4. DISCONNECT UPPER RADIATOR HOSE
5. DISCONNECT RADIATOR RESERVOIR HOSE
6. DISCONNECT LOWER RADIATOR HOSE
7. REMOVE RADIATOR NO.2 FAN SHROUD
8. A/T:
DISCONNECT OIL COOLER HOSES





9. REMOVE RADIATOR
Remove the 4 bolts and the radiator.
Torque: 12 Nm (120 kgf-cm, 8.7 ft. lbs.)

HINT: Insert the tabs of the radiator support through the radiator service holes.

DISASSEMBLY





1. REMOVE NO.1 FAN SHROUD
Remove the 4 bolts and No.1 fan shroud.





2. REMOVE RADIATOR SUPPORTS
Using a torx wrench, remove the 4 torx screws and the 2 radiator supports.
Torx wrench: T30 (Part No. 09042-00010 or locally manufactured tool)

HINT: Lift up the floor carpet and loosen the screw.

REASSEMBLY
Reassembly is in the reverse order of disassembly.

INSTALLATION
Installation is in the reverse order of removal.