Starter Relay: Testing and Inspection

1. REMOVE STARTER RELAY

LOCATION: The relay is located in the junction block on the driver's side.




2. INSPECT STARTER RELAY CONTINUITY
a. Using an ohmmeter, check that there is continuity between terminals 1 and 2.
If there is no continuity, replace the relay.
b. Check that there is no continuity between terminals 3 and 5.
If there is continuity, replace the relay.




3. INSPECT STARTER RELAY OPERATION
a. Apply battery voltage across terminals 1 and 2.
b. Using an ohmmeter, check that there is continuity between terminals 3 and 5.
If operation is not as specified, replace the relay.

4. REINSTALL STARTER RELAY