Rear End Door Glass Removal and Installation (Hatchback)

Rear End Door Glass Removal and Installation (Hatchback)

Rear End Door Window Components (Hatchback)

Refer to Windshield Removal and Installation Windshield Removal and Installation
as preparation, removal and installation procedures are basically the same. However, note the following.

- Observe the following precautions when applying adhesive (1) along glass (2) edge.
- Adhesive (1) should be applied evenly especially in height.
- Be careful not to damage primer (3).
- Install glass (2) on rear end door panel (5) noting the following.

- With the position of fastener (4) properly aligned.
- With the position of ceramic mark (6) aligned to the mark (7) of rear end door panel (5).

- Press glass against body quickly after adhesive (1) is applied.

Adhesive amount specifications and position for rear end door glass
Height "a": 13 mm (0.51 in.)
Width "b": 7 mm (0.28 in.)
Width "c": 14 mm (0.55 in.)
Position "d": 15 mm (0.59 in.)
Position "e": 42 mm (1.65 in.)
Position "f": 37 mm (1.46 in.)
Position "g": 9 mm (0.35 in.)
Position "h": 14 mm (0.55 in.)