Contact Coil Cable Assembly Removal and Installation

Contact Coil Cable Assembly Removal and Installation

Steering Wheel and Column Components

NOTE:

The contact coil will break if it is turned too much.

Do not turn the contact coil more than about two-and-a-half turns in either direction from the neutral position.

Removal

1) Disconnect negative (-) cable at battery.
2) Remove steering wheel from steering column referring to Steering Wheel Removal and Installation Steering Wheel Removal and Installation.
3) Remove steering column hole cover.
4) Remove steering column lower cover (2) and upper cover (1).





5) Remove contact coil cable assembly (1) with steering angle sensor (2) (ESP(R) model) from steering column.





6) For ESP(R) model, remove steering angle sensor from contact coil cable assembly referring to Steering Angle Sensor Removal and Installation (ESP Model) Steering Angle Sensor Removal and Installation (ESP(R) Model).

Installation

Contact Coil Cable Assembly Inspection

Centering Contact Coil Cable Assembly
1) Check to make sure that vehicle's front tires are set at straight-ahead position and then ignition switch is at LOCK position.
2) For ESP(R) model, install steering angle sensor to contact coil cable assembly referring to Steering Angle Sensor Removal and Installation (ESP Model) Steering Angle Sensor Removal and Installation (ESP(R) Model).
3) Install contact coil cable assembly with steering angle sensor (ESP(R) model) to steering column securely.

NOTE:
New contact coil cable assembly is supplied with contact coil set and held at its center position with a lock pin (1). Remove this lock pin after installing contact coil cable assembly to steering column.





4) Install steering column upper cover (1) and lower cover (2).

NOTE:
Lead wires will be damaged if they get pinched when you install the covers.

Make sure that there are no wires caught between the covers before securing the covers.









5) Install steering wheel to steering column referring to Steering Wheel Removal and Installation Steering Wheel Removal and Installation.
6) Connect negative (-) cable to battery.