Removal and Installation

MAF and IAT Sensor Removal and Installation

NOTE:

- Failure to take proper precautions when handling the MAF and IAT sensor may lead to malfunction of the sensor.

- Do not disassemble the sensors.
- Do not drop or otherwise expose the sensors to shock. Any MAF and IAT sensor that has been dropped must be replaced.
- Do not clean the sensors.
- Do not direct compressed air from an air gun or the like to the sensor.
- Do not put a finger or any other object into the sensor.

Removal

1) Disconnect negative (-) cable at battery.
2) Disconnect MAF and IAT sensor connector.
3) Remove MAF and IAT sensor (1) from air cleaner case (2).

Installation

MAF and IAT Sensor Inspection

Reverse removal procedure, noting the following points:

- Tighten MAF and IAT sensor screws (3) to specified torque.

Tightening torque
MAF and IAT sensor screw (a): 0.9 Nm (0.09 kgf-m, 1.0 lbf-ft)