Cylinder Block Heater Removal and Installation (If Equipped)

Cylinder Block Heater Removal and Installation (If Equipped)

Removal

1) Disconnect negative (-) cable at battery.
2) Drain coolant. Cooling System Draining
3) Remove exhaust manifold cover.
4) Remove block heater protector, and then disconnect block heater harness connector.
5) Remove cylinder block heater (1).











Installation

Cylinder Block Heater Inspection (If Equipped)

Reverse removal procedure for installation noting the following points:

- Use new cylinder block heater bolts.
- Tighten cylinder block heater bolts (1) to specified torque.

Tightening torque
Cylinder block heater bolt (a): 11 Nm (1.1 kgf-m, 8.5 lbf-ft)





- Refill coolant. Cooling System Refilling
- Check for coolant leaks. Initial Inspection and Diagnostic Overview