ABS Warning Light Does Not Come ON after Pressing Engine Switch to Change the Ignition Mode of Keyless Push Start System to "ON

ABS Warning Light Does Not Come ON after Pressing Engine Switch to Change the Ignition Mode of Keyless Push Start System to "ON"

Circuit Diagram

Refer to "Circuit Diagram" under ESP Warning Light Does Not Come ON after Pressing Engine Switch to Change the Ignition Mode of Keyless Push Start System to "ON ESP (R) Warning Light Does Not Come ON after Pressing Engine Switch to Change the Ignition Mode of Keyless Push Start System to "ON".

Circuit Description

Operation (ON/OFF) of ABS warning light is controlled by ESP (R) control module through light driver module in combination meter.

If antilock brake system is in good condition, ESP (R) control module turns ON ABS warning light when engine switch is pressed to change ignition mode to "ON", keeps it "ON" for 2 seconds and then turns it OFF. If any abnormality in the system is detected, ABS warning light is turned ON continuously by ESP (R) control module. Also, it is turned ON continuously by light driver module when the connector of ESP (R) control module is disconnected.

Troubleshooting

Refer to "Troubleshooting" under ESP Warning Light Does Not Come ON after Pressing Engine Switch to Change the Ignition Mode of Keyless Push Start System to "ON ESP (R) Warning Light Does Not Come ON after Pressing Engine Switch to Change the Ignition Mode of Keyless Push Start System to "ON".