P2096
DTC P2096 / P2097System and Wiring Diagram
Wiring Diagram:
Wiring Diagram:
DTC Detecting Condition and Trouble Area
DTC Confirmation Procedure
WARNING:
- When performing a road test, select a place where there is no traffic or possibility of a traffic accident and be very careful during testing to avoid occurrence of an accident.
- Road test should be carried out by 2 persons, a driver and a tester, on a level road.
NOTE:
- If DTC other than aimed DTC are previously detected in DTC confirmation procedure, be sure to troubleshoot DTC previously detected.
- Check that the following conditions are satisfied when using this procedure.
- ECT > 65 °C (149 °F)
1. Warm up engine to normal operating temperature.
2. Drive vehicle at 60 km/h (38 mile/h) or higher for 4 min.
DTC Troubleshooting
