Yaw Rate / G Sensor Assembly Removal and Installation
Yaw Rate / G Sensor Assembly Removal and InstallationCAUTION:
^ Regarding yaw rate / G sensor assembly removal/ installation, confirm specified torque and never use impact wrench to avoid damage.
^ When handling the yaw rate / G sensor assembly, be careful not to drop it or apply an impact to it. If an excessive impact was applied, never attempt disassembly or repair but replace it with a new one.
Removal
1. Disconnect negative (-) cable at battery.
2. Remove console box.
3. Disconnect connector from yaw rate / G sensor assembly.
4. Remove yaw rate G sensor assembly from sensor bracket.
Installation
1. Before installing yaw rate / G sensor assembly (1), check installing condition as follows.
^ Deformations around sensor installation area (2) (in sensor bracket).
^ Foreign matters on mating surface between sensor and sensor bracket.
2. Install yaw rate / G sensor assembly (1) to floor panel.
Tightening torque
Yaw rate / G sensor assembly bolt a: 6.5 Nm (0.65 kgf-m, 5.0 ft. lbs.)
3. Connect connector to yaw rate / G sensor assembly.
4. Install console box.
5. Connect negative (-) cable to battery.