Clutch Operating Cylinder Disassembly and Reassembly

Clutch Operating Cylinder Disassembly and Reassembly
Disassembly
1. Remove boot and then push rod.





2. Remove piston (2) by blowing compressed air into bolt hole (1) where hose was connected, using care to prevent it from jumping out.

Reassembly

NOTE: Before installation, wash each part in specified brake fluid.

1. Apply brake fluid to piston assembly and inside of cylinder.





2. Install piston assembly (1) into cylinder. When inserting it, be careful not to cause damage to lip of piston cup (2).
3. Install boot and push rod.