Rear Door Latch: Service and Repair

Rear Door Lock Assembly Removal and Installation

Rear Door Lock Assembly Components:

Removal
1. Remove rear door glass.
2. Disconnect door opening control rod (1) and door latch control rod (2).
3. Disconnect door lock motor lead wire (if equipped).
4. Loosen door latch mounting screw (3), door latch actuator bolt (4) and remove door latch assembly (5).







Installation
Reverse removal procedure to install rear door lock assembly referring to the following instruction and Front Door Lock Assembly Removal and Installation.
- Tighten out side rear handle mounting bolt first, and then tighten out side handle front mounting bolt.