Seals and Gaskets: Service and Repair

REPLACEMENT
1. Lift up vehicle and drain transmission oil.
2. Remove drive shaft joints from differential gear of transmission.
For differential side oil seal removal, it is not necessary to remove drive shafts from steering knuckle.





3. Remove differential side oil seal by using screw driver or like.
4. Install new differential side oil seal by using special tool.

NOTE: For oil seal installation, press-fit oil seal so that transmission case end face is flush with oil seal end face.

Special Tool
(A): 09944-66020
5. Install drive shaft.
6. Refill A/T fluid referring to FLUID CHANGE.