With Manufacturer's Scan Tool

[Using SUZUKI scan tool]
1. Turn ignition switch OFF
2. Connect SUZUKI scan tool to data link connector (DLC) in the same manner as when making this connection for DTC check.

Special Tools
(A): 09931-76011
(B): Mass storage cartridge
(C): 09931-76030

3. Turn ignition switch ON.
4. Erase DTC according to instructions displayed on SUZUKI scan tool.
Refer to SUZUKI scan tool operator's manual for further details.
5. After completing the check, turn ignition switch OFF and disconnect SUZUKI scan tool from data link connector (DLC).
6. Perform DIAGNOSIS TROUBLE CODE (DTC) CHECK and confirm that normal DTC (NO CODES) is displayed and not malfunction DTC.

NOTE:
- If DTC 51 or DTC 71 is stored in SDM, it is not possible to clear DTC.
- To clear DTC by using "AIR BAG" monitor coupler is not possible.