Sunroof / Moonroof Motor: Service and Repair

Sunroof Motor

REMOVAL

1. Completely close the glass lid.
2. Disconnect the ground cable from battery.
3. Remove the overhead console. (Models without EyeSight)
1. Push and open the rear end of the overhead console lid, and remove the screws.
2. Remove the clips and pull out the overhead console to disconnect the connectors.







4. Remove the stereo camera cover. (Models with EyeSight)
5. Remove the sunroof motor assembly.
1. Disconnect the connector.
2. Remove the bolts and remove the sunroof motor assembly.

CAUTION: When removing the motor assembly, secure the cable wires so that it does not move.







INSTALLATION

CAUTION: When installing the motor assembly, be careful not to move the sunroof cable.

1. Align the lid bracket and link assembly in the same position.







2. Install the sunroof motor assembly.
3. Install the spot map light, and connect the ground cable to the battery.
4. Perform the initialize operation.
5. Check the operation of sunroof with following table below.