Installation

Propeller Shaft

INSTALLATION

1) Before installation, check the following items, and replace the propeller shaft assembly as necessary.
^ Dents or cracks on the tube surface
^ Splines for deformation or abnormal wear
^ Unsmooth joint operation or abnormal noise
^ Center bearing for free play, noise or non-smooth operation.
^ Oil seals for abnormal wear or damage
^ Damaged center bearing
2) Apply fluid or gear oil to the oil seal lip and the propeller shaft.
^ CVT model: SUBARU CVT OIL FOR LINEARTRONIC
^ MT model: GL-5
3) Insert the sleeve yoke into the transmission and attach center bearing to body.





Tightening torque:
52 Nm (5.30 kgf-m, 38.4 ft-lb)
4) Align the alignment marks (A), and connect the yoke flange and rear differential.





Tightening torque:
31 Nm (3.16 kgf-m, 22.9 ft-lb)
5) Check the propeller shaft with the propeller shaft installed to the vehicle. Testing and Inspection
6) Install the heat shield cover.

Tightening torque:
18 Nm (1.84 kgf-m, 13.3 ft-lb)
7) Install the center exhaust pipe and rear exhaust pipe.
8) Lower the vehicle.