Curtain Airbag Module

Curtain Airbag Module

REMOVAL

CAUTION: Refer to "CAUTION" of "General Description" before handling the airbag module. Caution

1. Turn the ignition switch to OFF.
2. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work.
3. Remove the front pillar upper trim and center pillar upper trim.
- Front pillar upper trim
- Center pillar upper trim

4. Remove the rear quarter trim.
5. Remove the roof trim.
6. Disconnect the connector from curtain airbag module.
7. Remove the bolt, and remove the curtain airbag module.

CAUTION:
- Be careful not to damage the curtain airbag module during removal.
- Never open the curtain airbag module before deploying it. Never reuse the deployed curtain airbag module.






8. Remove the front pillar pad from the front pillar.






INSTALLATION

CAUTION:
- Refer to "CAUTION" of "General Description" before handling the airbag module. Caution
- When installing the curtain airbag module, install a specified part at specified place.
- Be careful not to damage the curtain airbag module during removal.
- Never open the curtain airbag module before deploying it. Never reuse the deployed curtain airbag module.
- Make sure that there are no foreign matter on airbag module.

Install in the reverse order of removal.

Tightening torque: 7.5 N.m (0.76 kgf-m, 5.5 ft-lb)