Removal

AT Shift Lock Solenoid and "P" Range Switch

REMOVAL

SOLENOID UNIT

1) Remove the AT select lever.
2) Remove the spacer and gasket.
3) Using a flat tip screwdriver with a thin tip, remove the harness connector from the plate COMPL.





4) Raise the claw using a flat tip screwdriver with a thin tip, and remove the solenoid unit from the plate COMPL.





5) Using a flat tip screwdriver with a thin tip, remove the solenoid unit terminals from the harness connector.





"P" RANGE SWITCH

For the removal of "P" range switch, refer to the procedure for AT select lever.