Removal

REMOVAL

1) Lift up the vehicle, and then remove the front wheels.
2) Lift the crimped section of axle nut.





3) Remove the axle nut using a socket wrench while depressing the brake pedal.

CAUTION:
Do not loosen the axle nut while the front axle is loaded. Doing so may damage the hub bearing.

4) Remove the disc brake caliper from the housing, and suspend it from strut using a wire.
5) Remove the disc rotor from the hub.

NOTE:
If it is difficult to remove the disc rotor from the hub, drive the 8 mm bolt into the threaded end of rotor, and then remove the rotor.





6) Remove the four bolts from the housing.





CAUTION:
^ Do not get closer the tool which charged magnetism to magnetic encoder.
^ Be careful not to damage the magnetic encoder.





7) Remove the front hub unit bearing. If it is hard to remove, use the ST.
ST1 926470000 AXLE SHAFT PULLER
ST2 28099PA110 AXLE SHAFT PULLER PLATE