Installation

INSTALLATION

1) Align the cutout portion (a) at serrated section of the column shaft (c) and yoke (b), then install the universal joint into column shaft.

CAUTION:
Be sure to align the protrusion section (a) of the column shaft side with the cutout (a) of the serration. If the protrusion is aligned with the other cutout (d), the universal joint bolt cannot be assembled.





2) Install the universal joint to the serrations of gearbox assembly by matching alignment marks.
3) Tighten the bolts.

CAUTION:
Excessively large tightening torque of universal joint bolts may lead to heavy steering wheel operation.

Tightening torque:
24 Nm (2.4 kgf-m, 17.7 ft-lb)
Clearance between coupling of universal joint and turbo cover:
15 mm (0.59 in) or more

4) Align the center position of the roll connector.
5) Install the steering wheel.