Installation

INSTALLATION

CAUTION:
^ Be sure to use a new self-locking nut.
^ Always tighten the bushing in the state where the vehicle is at curb weight and the wheels are in full contact with the ground.

1) Install each part in the reverse order of removal.

Tightening torque:
Rear suspension: Rear Suspension
Rear strut: Diagrams

2) Install the rear wheels.

Tightening torque:
120 Nm (12.24 kgf-m, 88.5 ft-lb)

3) Inspect the wheel alignment and adjust if necessary.
^ Inspection: Front Suspension
4) Perform reinitialization of the auto headlight beam leveler system. (model with auto headlight beam leveler)