Installation

INSTALLATION

1) Install the strut mount - front at the upper side of the strut to the body, and tighten it with new self-locking nuts.

Tightening torque:
20 Nm (2.04 kgf-m, 14.8 ft-lb)

2) Align alignment marks on the camber adjusting bolt and strut. Using new self-locking nuts, install the strut to the housing assembly - front axle.

NOTE:
While holding the head of adjusting bolt, tighten the self-locking nut.

Tightening torque:
155 Nm (15.81 kgf-m, 114.3 ft-lb)

3) Secure the ABS wheel speed sensor harness bracket to the strut.

CAUTION:
During the installation, make sure that the marking of ABS wheel speed sensor harness does not twist.

4) Install the brake hose bracket.

Tightening torque:
33 Nm (3.36 kgf-m, 24.3 ft-lb)

5) Install the front wheels.

Tightening torque:
120 Nm (12.24 kgf-m, 88.5 ft-lb)

6) Inspect the wheel alignment and adjust if necessary.
^ Inspection: Front Suspension
7) Perform reinitialization of the auto headlight beam leveler system. (model with auto headlight beam leveler)