Parking Brake Cable: Service and Repair

Parking Brake Cable

REMOVAL

1) Remove the lever assembly - hand brake.
2) Remove the nut and remove the clamp A - hand brake cable (a).
3) Remove the inner cable end (c) from the equalizer (b).





4) Remove the rear seat cushion assembly.
(1) Push the corners of the rear seat cushion from above.
(2) While pushing the corners of the rear seat cushion from above, pull the knob of the hook - seat cushion rear towards yourself.
(3) While pulling the knob towards yourself, disconnect the hooks by lifting up the rear seat cushion.

NOTE:
Pull the left side of the knob to disconnect the LH side hook, and pull the right side of the knob to disconnect the RH side hook.





(4) Remove the hook (A) by pushing it back while lifting the front side of the rear seat cushion, and remove the rear seat cushion.





5) Release the clips and claws, and remove the side sill covers - rear INN on the left and right sides.

CAUTION:
Do not pull with excessive force. Doing so may damage the claws of the side sill cover - rear INN.





6) Remove the clips and knobs of the hook - seat cushion rear.





7) Turn over the floor carpet and remove the grommet of the cable assembly - parking brake from the rear floor.
8) Lift up the vehicle, and then remove the rear wheels.
9) Remove the bolt and nuts and remove the protector - fuel tank.





10) Remove the cable assembly - parking brake from the lever section of parking brake shoe.
11) Remove the clamp B - hand brake cable (a) from the rear brake.
12) Remove the cable clamp (b) from the back plate - rear brake.
13) Remove the cable clamp (c) from the rear floor, and remove the cable assembly - parking brake.





INSTALLATION

1) Install each part in the reverse order of removal.

CAUTION:
Do not reuse the nut (self locking nut). Always replace with a new part.

Tightening torque:
Protector - fuel tank nut: 9 Nm (0.92 kgf-m, 6.6 ft-lb)
Protector - fuel tank bolt: 18 Nm (1.84 kgf-m, 13.3 ft-lb)
Cable clamp: 18 Nm (1.84 kgf-m, 13.3 ft-lb)
Rear wheel: 120 Nm (12.24 kgf-m, 88.5 ft-lb)

NOTE:
- Apply grease to the cable guide inside the tunnel, and pass the cable through.
- After installing the backrest assembly, make sure that each seat belt operates normally.
- Make sure that they are properly secured on each hook on the vehicle side.

2) Be sure to adjust the lever stroke.

INSPECTION

Check the removed cable and replace if damaged, rusty or malfunctioning.
1) Check the cable for smooth operation.
2) Check the inner cable for damage and rust.
3) Check the outer cable for damage, bends and cracks.