Sunroof / Moonroof Motor: Service and Repair

Sunroof Motor

REMOVAL

1. Completely close the lid assembly - sunroof.
2. Disconnect the ground cable from battery.
3. Remove the light assembly - map.
1. Remove the lens and detach the screws.







2. Release the clips and pull out the light assembly - map to disconnect the connectors.







4. Remove the motor assembly - sunroof.
1. Disconnect the harness connector.
2. Remove the screws and remove the motor assembly - sunroof.

CAUTION: When removing the motor assembly - sunroof, secure the cable assembly so that it does not move.







INSTALLATION

CAUTION: When installing the motor assembly - sunroof, be careful not to move the cable assembly.

1. Install the motor assembly - sunroof.
2. Install the light assembly - map, and connect the ground cable to the battery.
3. Perform the initialize operation.
4. Check the operation of sunroof with following table below.