Installation

Universal Joint

INSTALLATION

1) Align the cutout portion at serrated section of the column shaft and yoke, then install the universal joint into column shaft.
2) Install the universal joint to the serrations of gearbox assembly by matching alignment marks.
3) Tighten the bolts on the gearbox side first, and then the column shaft side.

Tightening torque:
24 Nm (2.4 kgf-m, 17.7 ft-lb)

CAUTION:
Be sure to follow the tightening order and tightening torque of universal joint to avoid the steering effort from becoming heavy.

Clearance between coupling of universal joint to AT level gauge:
10 mm (0.39 in) or more

4) Align the center position of the roll connector.
5) Install the steering wheel.