Procedures

FORCED DRIVE

If the glass lid does not operate or the sunroof motor is not supplied with power, move the glass lid using the hexagon wrench.

Width across flat 5 mm (0.20 in)

CAUTION: After a forced operation, make sure to perform an initialize operation. [Ref. to INITIALIZE OPERATION, OPERATION, Sunroof Control System.]

1. Remove the spot map light.
2. Insert the hexagon wrench securely until it touches the motor shaft edge.
3. Turn the hexagon wrench, and move the glass lid.
- Turning right, the glass lid open.
- Turning left, the glass lid close.

CAUTION: Be careful not to damage the adjacent parts with the rod end when moving the glass lid with the hexagon wrench.