Rear Differential Front Member
Rear Differential Front MemberREMOVAL
1) Disconnect the ground cable from battery.
2) Lift up the vehicle.
3) Support the rear differential using transmission jack, and then remove the rear differential front member.
INSTALLATION
Install the rear differential front member with a new self-locking nut.
Tightening torque:
T1: 50 Nm (5.1 kgf-m, 36.9 ft-lb)
T2: 110 Nm (11.2 kgf-m, 81.1 ft-lb)
INSPECTION
1) Check the rear differential front member for damage, bend and corrosion. If damage, bend or corrosion is excessive, replace the rear differential front member.
2) Check the bushings of rear differential member for cracking, hardening and damage. If cracking, hardening or damage is excessive, replace rear differential front member.