Automatic Transmission Dipstick - Dipstick Tube: Service and Repair
Oil Charge PipeREMOVAL
1) Remove the air intake boot assembly. (non-turbo model)
2) Remove the intercooler. (turbo model)
3) Remove the starter.
4) Remove the oil charge pipe, and then remove the O-ring from the flange side.
INSTALLATION
1) Install the oil charge pipe with O-ring.
NOTE:
^ Use new gaskets and O-rings.
^ Apply ATF to the O-ring.
Tightening torque:
38 Nm (3.9 kgf-m, 28.0 ft-lb)
2) Install the starter.
3) Install the air intake boot assembly. (non-turbo model)
4) Install the intercooler. (turbo model)
INSPECTION
Make sure the oil charge pipe is not deformed or damaged.