Rear Trailing Link

Rear Trailing Link

REMOVAL

1) Lift up the vehicle, and then remove the rear wheels.
2) Remove the bracket, and remove the parking brake cable from the guide (1).





3) Remove the trailing link.





INSTALLATION

CAUTION:
^ Be sure to use a new self-locking nut.
^ Always tighten the bushing in the state where the vehicle is at curb weight and the wheels are in full contact with the ground.

Install each part in the reverse order of removal.

Tightening torque:
90 Nm (9.18 kgf-m, 66.4 ft-lb)