Rear Arm

Upper Arm

REMOVAL

1) Lift up the vehicle, and then remove the rear wheels.
2) Remove the rear ABS wheel speed sensor bracket.





3) Remove the bolts, then remove the upper arm.





INSTALLATION

CAUTION:
^ Use a new self-locking nut.
^ Always tighten the bushing when the arm is positioned in the state where the vehicle is at curb weight and the wheels are in full contact with the ground.

1) Install each part in the reverse order of removal.
2) Inspect the wheel alignment and adjust if necessary. Front Suspension

Tightening torque:
Upper arm - Rear sub frame
150 Nm (15.30 kgf-m, 110.6 ft-lb)
Upper arm - Rear housing
80 Nm (8.16 kgf-m, 59.0 ft-lb)
Rear ABS wheel speed sensor bracket
7.5 Nm (0.76 kgf-m, 5.5 ft-lb)