Brake Pipe

Brake Pipe

REMOVAL

CAUTION:
^ Yellow connectors and harnesses with yellow tapes around them are the connectors and harnesses for the airbag system. Using a tester above such circuits may cause malfunction of airbag system. Follow the cautions for the airbag system in this case.
^ Be careful not to damage the airbag system wiring harness when servicing the center brake pipe.
^ When removing the brake pipe, do not bend.

NOTE:
The airbag system wiring harness is routed near the center brake pipe.

INSTALLATION

CAUTION:
^ Yellow connectors and harnesses with yellow tapes around them are the connectors and harnesses for the airbag system. Using a tester above such circuits may cause malfunction of airbag system. Follow the cautions for the airbag system in this case.
^ Be careful not to damage the airbag system wiring harness when servicing the center brake pipe.
^ When installing the brake pipe, do not bend.
^ After installing the brake pipe and hose, perform air bleed.
^ After installing the brake hoses, make sure that they do not contact the tires or suspension assembly, etc.

NOTE:
The airbag system wiring harness is routed near the center brake pipe.

Brake pipe tightening torque:
Refer to "COMPONENT" of "General Description".

INSPECTION

Make sure there are no cracks, breakage or damage on hoses. Check the joint for fluid leakage. If any cracks, breakage, damage or fluid leakage is found, repair or replace the pipes.

NOTE:
Use a mirror when inspecting back sides and other locations which are hard to see.