Lower Inner Trim

LOWER INNER TRIM

REMOVAL

1. Release the claws, and then remove the side sill cover-front INN.

3. Remove the rear seat cushion assembly.
1. Pull up the seat cushion and release the hook.

CAUTION: If the hook is removed from vehicle body, replace the hook with the new part to avoid the deterioration of seat securing.

2. Remove the hook (A) by pushing it back while lifting the front side of the seat cushion, and remove the seat cushion.

4. Release the clips and claws, and then remove the side sill cover - rear INN.

CAUTION: Do not pull with excessive force. Doing so may damage the claws of the side sill cover INN.

NOTE: To release the claws of the side sill cover INN, the following steps are recommended.

1. Take out the weather strip from under the side sill cover INN.
2. Turn over the floor mat and release the claws (C) and (D) by accessing from behind the side sill cover INN.

5. Remove the center pillar trim LWR.
1. Release the clip by pulling the center pillar trim LWR toward you.
2. Expand the claws of center pillar trim LWR outward and remove it from the center pillar trim UPR.

CAUTION: Do not expand the center pillar trim LWR excessively. Doing so may damage the trim.

NOTE: First release the claw located to the rear of the vehicle.

6. Release the claws, and then remove the side sill cover-front OUT.

7. Release the claws and metal clips, and then remove the side sill cover-rear OUT.

INSTALLATION

Install each part in the reverse order of removal.

CAUTION: If the hook is removed from vehicle body, replace the hook with the new part to avoid the deterioration of seat securing.

NOTE: Assemble the center pillar trim LWR to the center pillar trim UPR securely.