Trunk / Liftgate Latch: Service and Repair
Rear Gate Latch and Actuator AssemblyREMOVAL
1. Disconnect the ground cable from battery.
2. Remove the rear gate trim.
3. Remove the rear gate latch & actuator assembly
1. Remove the bolts and pull out the rear gate latch & actuator assembly to the vehicle front.
2. Disconnect the connectors, and then remove the rear gate latch & actuator assembly.
INSTALLATION
Install each part in the reverse order of removal.
REAR GATE LOCK AND TRUNK LID LOCK
Tightening torque: N.m (kgf.m, ft.lb)
T1: 7.5 (0.76, 5.5)
T2: 25 (2.5, 18.4)
T3: 18 (1.8, 13.3)