Symptom Related Diagnostic Procedures

SUNROOF CONTROL SYSTEM

INSPECTION







- Failure turn of glass lid while driving rough road.
Glass lid has auto-reverse function. When specified or more force is applied to the glass lid, the lid turns back and stops. When operating the glass lid (open or close) while driving the rough road, the lid judges vibration as a force and may causes failure turns. When the failure turn is occurred, need to perform the initialize operation with following procedure.

OPERATION

1. INITIALIZE OPERATION

NOTE: When initialize operation is performed, it is necessary to press the switch repeatedly as it operates for only at the moment when the switch is pressed, even when the switch is held down.

1. Press the slide switch to close the glass lid completely.
2. Press the slide switch again and tilt up the glass lid to lock.
3. Press the slide switch for more than 0.3 seconds.
4. Initialize operation is completed.

NOTE For operation procedures of each component of the sunroof control system, refer to the respective section.
- Glass lid: [Ref. to Glass Lid.]
- Sunroof assembly: [Ref. to Sunroof Assembly.]
- Sunroof motor: [Ref. to Sunroof Motor.]
- Sunroof switch: [Ref. to Sunroof Switch.]
- Sunshade: [Ref. to Sunshade.]