Removal

Front Hub Unit Bearing

REMOVAL
1) Lift up the vehicle, and remove the front wheels.
2) Lift the crimped section of axle nut.





3) Remove the axle nut using a socket wrench while depressing the brake pedal.

CAUTION:
Do not loosen the axle nut while the front axle is loaded. Doing so may damage the hub bearing.

4) Remove the front ABS wheel speed sensor.





5) Remove the front disc brake and hang it to the front strut.
6) Remove the disc rotor.

NOTE:
If it is difficult to remove the disc rotor, drive the 8 mm bolt into the threaded end of rotor, and remove the rotor.





7) Remove the four bolts from the housing.





CAUTION:
^ Do not get closer the tool which charged magnetism to magnetic encoder.
^ Be careful not to damage the magnetic encoder.





8) Remove the front hub unit bearing. If it is hard to remove, use the ST.
ST1 926470000 AXLE SHAFT PULLER
ST2 28099PA110 AXLE SHAFT PULLER PLATE