Installation

Front Hub Unit Bearing

INSTALLATION
1) Place the disc brake cover between housing and front hub unit, and tighten the four bolts.





2) Install the front drive shaft.
3) Tighten the axle nut temporarily.
4) Install the disc rotor to hub.
5) Install the disc brake caliper on the housing.
Tightening torque:
120 Nm (12.2 kgf-m, 88.5 ft-lb)
6) Install the front ABS wheel speed sensor.
Tightening torque:
7.5 Nm (0.76 kgf-m, 5.5 ft-lb)
7) While depressing the brake pedal, tighten a new axle nut to the specified torque and lock it securely.
Tightening torque:
220 Nm (22.4 kgf-m, 162.3 ft-lb)

CAUTION:
Do not load the front axle before tightening the axle nut. Doing so may damage the hub bearing.

8) After tightening the axle nut, lock it securely.





9) Install the wheel.
Tightening torque:
120 Nm (12.2 kgf-m, 88.5 ft-lb)