Warning Light Illumination Pattern
Warning Light Illumination PatternINSPECTION
Warning Light Illumination Pattern:
NOTE:
^ The illumination pattern above shows proper condition.
^ While hill start assist is OFF, hill start assist warning light (15) always illuminates to indicate that hill start assist does not operate.
1) When warning lights or indicator lights do not illuminate in accordance with this illumination pattern, there must be an electrical malfunction.
2) When warning lights or indicator lights remain constantly OFF, check the combination meter circuit or CAN communication circuit.
3) When ABS warning light does not go off, check the combination meter circuit or CAN communication circuit.
4) When hill start assist warning light does not go off, check the status of hill start assist OFF mode setting, combination meter circuit, or CAN communication circuit.
5) When the VDC operation indicator light, VDC warning light and VDC multi mode indicator light do not turn off, check the combination meter circuit or CAN communication circuit.
NOTE:
^ Even though the ABS warning light does not go off after 2 seconds from ABS warning light illumination, the ABS system operates normally when the warning light goes off while driving at approximately 12 km/h (7 MPH). However, the ABS system does not work while the ABS warning light is illuminated.
^ It may take several minutes before VDC warning light and VDC multi mode indicator light turns off if the vehicle is parked under low temperatures for some time. This is not defective because it is resulted from low engine coolant temperature.
^ With the vehicle jack stands/lifted or set on free rollers, when the wheels lock or spin after starting the engine, the ABS warning light, VDC warning light and VDC multi mode indicator light may illuminate because VDCCM&H/U detects an abnormal condition from the ABS wheel speed sensors. In this case, this is not a malfunction. Perform the Clear Memory Mode. Clear Memory Mode
6) Warning light illumination pattern at VDC multi mode change
If the VDC warning light and VDC multi mode indicator light illumination pattern when the VDC mode change switch is operated do not match the following, check the VDC mode change switch circuit, CAN communication circuit or combination meter circuit.
Warning light illumination pattern at VDC multi mode change:
7) Warning light illumination pattern at hill start assist OFF mode change
When the VDC OFF switch is kept pressing, VDC warning light and VDC multi mode indicator light illuminates at first in green then in yellow then goes off in approx. 8 seconds. If the switch is released in 5 seconds after the light goes off then pressed again in 2 seconds, hill start assist warning light illuminates then mode is changed to hill start assist OFF mode. If hill start assist function ON/OFF does not change, check VDC mode change switch circuit, CAN communication circuit or combination meter circuit.
Warning light illumination pattern at hill start assist OFF mode change:
NOTE:
^ While hill start assist is OFF, hill start assist warning light always illuminates to indicate that hill start assist does not operate.
^ For procedure of changing hill start assist function ON/OFF, refer to "Hill start assist".