Rear Vehicle Speed Sensor

Rear Vehicle Speed Sensor
REMOVAL
1. Set the vehicle on a lift.
2. Disconnect the ground cable from battery.
3. Lift up the vehicle.
4. Clean the transmission exterior.
5. Drain the ATF completely.
6. Remove the center and rear exhaust pipes and the muffler. (Turbo model.
7. Remove the rear exhaust pipe and muffler. (Non-turbo model.
8. Remove the heat shield cover.





9. Remove the propeller shaft.
10. Place the transmission jack under the transmission.

NOTE: Make sure that the support plate of transmission jack does not touch the cross.

11. Remove the transmission rear crossmember bolt.





12. Lower the transmission jack.

NOTE: Do not separate the transmission jack and transmission.

13. Disconnect the rear vehicle speed sensor connector.





14. Remove the rear vehicle speed sensor.





INSTALLATION
1. Install the rear vehicle speed sensor.
Tightening torque: 7 N-m (0.7 kgf-m, 5.2 ft-lb)





2. Connect the rear vehicle speed sensor connector.





3. Install the transmission rear crossmember bolt.
Tightening torque: 75 N-m (7.6 kgf-m, 55.3 ft-lb)
4. Install the propeller shaft.
5. Install the heat shield cover.





6. Install the center, rear exhaust pipes and the muffler. (Turbo model.
7. Install the rear exhaust pipe and muffler. (Nonturbo model.
8. Lower the vehicle.
9. Pour ATF from the oil charge pipe.
10. Check the level and leaks of ATF.