Extension Case Oil Seal
REPLACEMENT1. Lift up the vehicle.
2. Clean the transmission exterior.
3. Remove the ATF drain plug to drain ATF.
CAUTION: Immediately after the vehicle has been running or after idling for a long time, the ATF will be hot. Be careful not to burn yourself.
4. Tighten the ATF drain plug.
NOTE: Use a new gasket.
Tightening torque: 20 N-m (2.0 kgf-m, 14.8 ft-lb)
5. Remove the rear exhaust pipe and muffler. (Turbo model.
6. Remove the rear exhaust pipe and muffler. (Non-turbo model.
7. Remove the heat shield cover.
8. Remove the propeller shaft.
9. Using the ST, remove the oil seal. ST 398527700 PULLER ASSY
10. Using the ST, install the oil seal. ST 498057300 INSTALLER
11. Install the propeller shaft.
12. Install the heat shield cover.
13. Install the rear exhaust pipe and muffler. (Turbo model.
14. Install the rear exhaust pipe and muffler. (Nonturbo model.
15. Pour ATF from the oil charge pipe.
16. Check the level and leaks of the ATF.