Fuel Sub Level Sensor

Fuel Sub Level Sensor

REMOVAL

WARNING: Place "NO OPEN FLAMES" signs near the working area.

CAUTION:
- Be careful not to spill fuel.
- If the fuel gauge indicates that two thirds or more of the fuel is remaining, be sure to drain fuel before starting work to avoid the fuel to spill.

1. Release the fuel pressure.
2. Drain fuel.
3. Disconnect the ground cable from battery.






4. Remove the rear seat.
5. Remove the service hole cover.
1. Remove bolt (A).
2. Push the grommet (B) down and remove the service hole cover.






6. Disconnect the connector from the fuel sub level sensor.






7. Disconnect the quick connector on the fuel delivery hose and jet pump hose.
8. Remove the nuts and bolts which install fuel sub level sensor on fuel tank.






9. Remove the fuel sub level sensor.

INSTALLATION

Install in the reverse order of removal while being careful of the following.

- Make sure the sealing portion is free from fuel or foreign matter before installation.
- Align protrusion (A) of the gasket to the position shown in the following figure.
- Align the protrusion (B) of fuel sub level sensor with the cutout on the upper plate of fuel sub level sensor.
- Tighten the nuts and bolts to the specified torque in the order as shown in the figure.

NOTE: Use a new gasket and retainer.