Rear Shelf: Service and Repair

REAR SHELF TRIM

REMOVAL
1. Disconnect the ground cable from the battery.
2. Remove the rear seat cushion. [Ref. to SEDAN MODEL, REMOVAL, Rear Seat.]
3. Remove the backrest shoulder. (Right and left)







1. Remove the bolt.
2. Moving the lower side of backrest shoulder to the direction of arrow, and remove it from the stud bolt.
3. Lift to remove the backrest shoulder.

4. Tilt the seat backrest forward.
5. Remove the clip, and remove the rear bulkhead panel upper.







6. Remove the rear quarter trim. [Ref. to, SEDAN MODEL, REMOVAL, Rear Quarter Trim.]
7. Remove the high-mounted stop light.
8. After disconnecting the high-mounted stop light harness connector (A) and removing the five clips, remove the rear shelf trim by pulling it frontward.







INSTALLATION

Install in the reverse order of removal.

NOTE: Securely insert the vehicle body panel into the hook of the rear shelf trim center, and install the rear shelf trim.