Clear Memory Mode

Clear Memory Mode

OPERATION

1. ECM
1. On the [[Main Menu]] display, select the {Each System Check}.
2. On the [[System Selection Menu]] display, select the {Engine Control System}.
3. Select the [OK] after the information of engine type is displayed.
4. On the [[Engine Diagnosis]] display, select the {Clearing Memory}.
5. When "Done" is displayed on the display, end the Subaru Select Monitor and turn the ignition switch to OFF.

NOTE:
- After the memory is cleared, initial diagnosis of the electronic throttle control is performed. Wait for 10 seconds or more after turning the ignition switch to ON, and then start the engine.
- For detailed operation procedures, refer to the "PC application help for Subaru Select Monitor".

2. BODY INTEGRATED UNIT
1. On the [[Main Menu]]display, select the {Each System Check}.
2. On the [[System Selection Menu]] display, select the{Integ. Unit}.
3. After {Integ. Unit} is displayed, select [OK].
4. On the [[Integ. unit mode failure diag]] display, select the {Clearing Memory}.
5. When "Done" is displayed on the display, end the Subaru Select Monitor and turn the ignition switch to OFF.

NOTE: For detailed operation procedures, refer to the "PC application help for Subaru Select Monitor".