6MT

REPLACEMENT
1. Lift up the vehicle.
2. Remove the front exhaust pipe and center exhaust pipe.
3. Drain transmission gear oil completely.
4. Separate the front drive shaft from the transmission.
5. Remove the differential side retainer oil seal by using a flat tip screwdriver or similar tools.
6. Using the ST, install the differential side retainer oil seal by lightly tapping with a hammer.
ST 18675AA000 DIFFERENTIAL SIDE OIL SEAL INSTALLER
7. Apply transmission gear oil to the oil seal lips.
8. Set the ST to the side retainer.
ST 28399SA010 OIL SEAL PROTECTOR
9. Install the front drive shaft into the transmission.

NOTE: Replace the circlip of drive shaft with a new part.

10. Install the front drive shaft into transmission, remove the ST and insert the drive shaft securely.
ST 28399SA010 OIL SEAL PROTECTOR
11. Install the front exhaust pipe and the center exhaust pipe.
12. Lower the vehicle.
13. Fill with transmission gear oil through the oil level gauge hole.
Recommended gear oil. GL-5 (75W-90.or equivalent
Transmission gear oil capacity. 4.1 l (4.3 US qt, 3.6 Imp qt)
14. Check the level of the transmission gear oil.